User guide

INSTALLING BROOKTROUT DRIVERS ON WINDOWS
19
From the main installation program
For details on the wizards, refer to Driver installation and configuration procedure
.
From a standalone installation program
You may launch the Brooktrout fax driver's setup separately from the server setup at any time. This is the
recommended method in case of a fresh installation.
When setting up a TR1034 or TruFax board, you can also choose to install the server without the Brooktrout drivers
support and install the support component separately afterwards if you want to evaluate the product with the
loopback (demonstration software) before setting up production fax boards.
To launch the driver configuration through an independent process:
1. Run the setup.exe file located in the server\w32\bt1034 sub-folder of the VSI-FAX CD-ROM.
2. This launches the VSI-FAX Dialogic Brooktrout TR1034-SR140 Support installation wizard. You can now
follow the steps described in Driver installation and configuration procedure
.
From the main installation program
1. If you previously set the VSI-FAX Server service startup type to Manual, set it to Automatic now.
2. Launch the server main setup.
3. When asked if you wish to install Brooktrout TR1034, TruFax or SR140 drivers now, click Yes:
4. This launches the VSI-FAX Dialogic Brooktrout TR1034-SR140 Support installation wizard. You can now
follow the steps described in Driver installation and configuration procedure
.
Refer to Installing VSI-FAX Server on Windows in the Installation and Administration
documentation for information
about non-board specific installation steps.
Driver installation and configuration procedure
1. Whatever the method used to launch the driver support installation (main setup or standalone setup), you may
obtain a warning message saying that the Brooktrout driver are not detected: