User guide

FAX BOARDS AND FAX DRIVERS INSTALLATION

7. Open the Device Manager and check that the Brooktrout device appears with no error:

If the device appears with an error, try to reboot the server and repeat the Plug and Play installation.

Now that you have installed/updated the Plug and Play driver, you can launch VSI-FAX Server setup. During the

server upgrade, you will configure your Brooktrout board with the new driver you have just upgraded to. For details,

refer to Configuring the Brooktrout driver for TR1034, TruFax boards or SR140

(page 18).

Configuring the Brooktrout driver for

TR1034, TruFax boards or SR140

You need to install the VSI-FAX Dialogic Brooktrout TR1034-SR140 Support component and use the Brooktrout

Configuration Tool to configure your fax platform.

With a TR1034 or TruFax board, this will allow you to configure your board parameters.

With SR140 software, this will allow you to register your SR140 license and configure Fax over IP.

The installation and configuration of the Brooktrout driver for VSI-FAX can be performed:

From a standalone installation program