User guide

INSTALLING BROOKTROUT DRIVERS ON WINDOWS

3. Click Finish when the installation is completed:

4. Open the Device Manager and check that the Brooktrout device appears with no error:

If the device appears with an error, try to reboot the server and repeat the Plug and Play installation.

Now that you have installed/updated the Plug and Play driver, you can launch VSI-FAX Server setup. During the

server upgrade, you will configure your Brooktrout board with the new driver you have just upgraded to. For details,

refer to Configuring the Brooktrout driver for TR1034, TruFax boards or SR140

(page 18).

Plug and Play driver installation on Windows Server 2008

Follow the steps below if you are setting up a fax platform running Windows Server 2008 (be it a fresh installation of

the Plug and Play driver or an upgrade):

1. The Found New Hardware wizard appears after reboot. Click Locate and install driver software

(recommended):