User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 305
Diagnostics
9.7 Diagnostic Commands
This section describes a number of diagnostic commands and includes:
• Devstat Command
• Restart Command
• Ping Command
• Ver Command
• Alarm List Command
9.7.1 Devstat Command
The Devstat command displays the current high-level settings of the unit and the unit's main status
and telephony port status. The telephony port state can be 'In Service', 'Out of Service', or 'Active'.
'Active' means that the port is off-hook. 'In Service' means that the port is available for use, but is
currently not in use. 'Out of Service' means that the port is disconnected.
PIMG>devstat
Description Value
======================================================================
sysStartType 0x0
MAC 00-a0-e6-02-01-19
IP 10.0.1.110
Subnet Mask 255.255.255.0
Gateway 10.0.1.1
Host 10.0.1.63
Status OK
Port 1 Active
Port 2 In Service
Port 3 In Service
Port 4 In Service
Port 5 In Service
Port 6 In Service
Port 7 In Service
Port 8 In Service
9.7.2 Restart Command
The Restart command causes the unit to warm-boot.
restart
9.7.3 Ping Command
The Ping command generates ICMP requests to the specified IP address. This is useful in
determining connection status to IP endpoints, gateways, or routers.