User`s guide

274 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Diagnostics
9.2.2.1 Configuration Options
The following configuration items are available to be modified by the user:
Test Selection
Choose the type of diagnostic test to perform. Available options are Initiate Call and Send
Message Waiting Status.
Interface Selection
Select the specific interface to use in the diagnostic test. If a specific interface is not chosen the
test will select the first interface available.
Channel Selection
Select the specific interface to use in the diagnostic test. If a specific interface is not chosen the
test will select the first interface available. This option is only available on TDM interfaces that
have more than one bearer channel.
Destination Number
The required number of the TDM endpoint that the diagnostic test will use when attempting
to establish a connection. If this configuration is empty the diagnostic test will not be
performed.
Source Name
The alphanumeric name representing the source party that is delivered to the destination
endpoint during the diagnostic test. This is an optional field that is not required to perform the
diagnostic test.
Source Number
The number representing the source party that is delivered to the destination endpoint during
the diagnostic test. This is an optional field that is not required to perform the diagnostic test.
Messages Waiting Status
Choose the status value of the message waiting notification update. This field is only valid
when the Message Waiting diagnostic test is selected.
9.2.2.2 Test Status
When a diagnostic test is executed the test results are shown in the TDM Interface Test Status table
on the Web page.
The test can be canceled at any time by pressing the Cancel Test button.
When the test is completed a hyperlink will be displayed to allow the user to return to the TDM
Interface Test configuration Web page.
Figure 50. TDM Interface Test Status Web Page