User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 273
Diagnostics
The Media Gateway diagnostic utilities are accessible via the Web interface by selecting the
Diagnostics link on the left side menu of any Web page.
9.2.2 TDM Interface Test Operation
To operate the TDM interface diagnostic tool, the user must first navigate to the Tests-->TDM link
via the Media Gateway’s user interface.
In the TDM Interface Test Configuration table:
1. Choose the diagnostic test to perform by selecting one of the options in the Test Selection
field.
2. The user must fill in the Destination Number field of the TDM endpoint that the
diagnostic test will use when attempting to establish a connection.
3. Optionally, select the interface and channel index of the gateway to use in the diagnostic
test by choosing the Interface Selection or Channel Selection. If Automatic is chosen the
test will select the first interface and channel available.
4. Fill in any optional source party information (Source Name and Source Number) that
will be delivered to the destination endpoint during the diagnostic test.
5. If the message waiting diagnostic test is selected, choose the Messages Waiting Status to
be used in the message waiting notification request.
To start the specified diagnostic test, press the Start Test button on the Web page.
Note: Executing the TDM interface diagnostic tool temporarily disables gateway functionality. Any
active connections will be released.
Figure 49. TDM Interface Web Page