User`s guide

270 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Diagnostics
9.1.2 VoIP Interface Test Operation
To operate the VoIP interface diagnostic tool, the user must first navigate to the Tests-->VoI P link
via the Media Gateway’s user interface.
In the VoIP Interface Test Configuration table:
1. Choose the diagnostic test to perform by selecting one of the options in the Test Selection
field.
2. Then the user must fill in the Destination VoIP Address field of the VoIP endpoint that
the diagnostic test will use when attempting to establish a connection.
3. Fill in any optional source party information (Source Name and Source Number) that
will be delivered to the destination endpoint during the diagnostic test.
4. If the message waiting diagnostic test is selected, choose the Messages Waiting Status to
be used in the message waiting notification request.
To start the specified diagnostic test, press the Start Test button on the Web page.
Note: Executing the VoIP interface diagnostic tool temporarily disables gateway functionality. Any active
connections will be released.
Figure 46. VoIP Interface Web Page
9.1.2.1 Configuration Options
The following configuration items are available to be modified by the user:
Test Selection
Choose the type of diagnostic test to perform. Available options are Initiate Call and Send
Message Waiting Status.
Destination VoIP Address
The required address of the VoIP endpoint that the diagnostic test will use when attempting to
establish a connection. If this configuration is empty the diagnostic test will not be performed.