User`s guide

Routing Table
228 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
5. Set up Inbound VoIP Rules.
Inbound VoIP Rules
Enable Rule Label Request Type Originating VoIP Host Address
X All Inbound VoIP Any *
Inbound VoIP Request Matching
CPID Matching
Calling
Number
Called
Number
Redirect
Number
* *
*
Calling
Name
Called
Name
Redirect
Name
* *
*
Outbound Routes
Device Selection
Outbound
Destination
Trunk
Group
TDM Any TDM channel
CPID Manipulation
Calling
Number
Called
Number
Redirect
Number
S D R
Calling
Name
Called
Name
Redirect
Name
S D R
Select Primary/Alternate Route
• Primary
o Alt-1 o Alt-2 o Alt-3 o Alt-4
6. Validate the Routing Table.
The only difference from Example #1 is when simulating Inbound TDM calls.
Since Example #2 uses load balancing, each time you click on Simulate Route the Outbound
Route’s Host should change. The following table shows this.
Outbound Route
VoIP
Device
Bridged
Method
cycles through these
172.16.3.1
172.16.3.2
172.16.3.3
Host
0
IP Port
156
Calling Number
Bill
Calling Name
213
Called Number
Mary
Called Name
Redirect Number
Redirect Name