User`s guide

Routing Table
Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 225
Input:
Inbound Route
o Inbound TDM
• Inbound VoIP
Request Type
Call
Host
172.13.4.3
IP Port
Calling Number
100
Calling Name
William
Called Number
210
Called Name
Jane
Redirect Number
165
Redirect Name
Mike
Output:
Test Results
Results
Test Passed
Reason
Inbound Rule
All VoIP Requests
Outbound Group
Any TDM Channel
Outbound Route
VoIP
Device
Bridged
Method
1 (see Note) Port
1 (see Note) Channel
100
Calling Number
William
Calling Name
210
Called Number
Jane
Called Name
165
Redirect Number
Mike
Redirect Name
Note: Since the TDM Trunk Group, Any TDM Channel, is ascending – cyclic each time
you click on Simulate Route the port & channel is updated to the next one (with wrapping).
Also, the simulation remembers where it was so if you come back to the simulation the port &
channel pick up where they were. Therefore, you may not see port = 1 and channel = 1, but
make sure each time you click Simulate Route the port & channel update.
• Click on Simulate Route a few times – the port & channel should cycle through all
possibilities.
• Try a few different values for Request Type and Host.
• Validation Finished.