User`s guide

210 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Routing Table
Called Party Name - The formula as specified in the section above that is used to match the called
name of the incoming call.
Redirecting Party Number - The formula as specified in the section above that is used to match
the redirect number of the incoming call.
Redirect Party Name - The formula as specified in the section above that is used to match the
redirect name of the incoming call.
5.2.3.3 Outbound Routes
Defines how the request is to be routed by the gateway. This defines the network to which the
request is to be routed as well as the CPID Manipulation expressions that are to be used to
manipulate CPID prior to routing the request.
Device Selection
Specifies the destination network of the route and how the request is to be routed.
Figure 33 is a screen shot of the Device Selection configuration Web page:
Figure 33. Device Selection Configuration Web Page
Outbound Destination - Specifies the network to which the request is to be routed:
– VoIP = Route to the VoIP network.
– TDM = Route to the TDM network.
– Blocked = Request is not routed. The inbound request will be immediately rejected.
Host Group - Name of VoIP Host Group to which the request is to be routed.
Note: This selection box is only present when the Outbound Destination is set to VoIP.
Trunk Group - Name of TDM Trunk Group to which the request is to be routed.
Note: This selection box is only present when the Outbound Destination is set to TDM.
Route Method - Method used for routing requests:
– Redirect = Request is redirected to the destination. The gateway does not bridge the two
networks. This is valid only when routing from/to the same network.
– Bridged = Request is bridged through the gateway between the inbound and outbound
network.
Note: This selection box is only supported on DMG2000. If the Outbound Destination is VoIP on
DMG1000, then the Route Method is forced to Redirect.