User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 197
Routing Table
5.2.2.1 Inbound TDM Rules
Use this table to define the routing rules for all telephony requests that are inbound from the TDM
network. Rules are evaluated from the top down until a matching rule is found.
Figure 25 is a screen shot of the Inbound TDM Rules configuration Web page:
Figure 25. Inbound TDM Rules Configuration Web Page
Select to configure the routing rules for requests that are inbound from the TDM network.
Select - Click anywhere in this column to select an entry. When a rule is highlighted, the associated
configuration is shown in the tables below. The selected row may be moved up or down in the table
by dragging and dropping it into a different position in the list, or deleted. The selected row may
also be moved by clicking on the Move Selected Row buttons: Up, Down, or To Position.
Note: It is a common error to modify the configuration of the incorrect rule. Make sure that the correct
rule is selected before modifying the configuration.
Enable - Check this box to enable the rule. If this box is not checked, this rule is not checked for
incoming calls.
Rule Label - Specifies the label for this entry. This label is used only to help identify the rule to the
administrator. It is not used by any other tables in the Routing Table configuration.
Request Type - Specifies the type of telephony request to which the rule applies:
– Any = All telephony request types.
– Call = Calls only.
– Message = Message-waiting notifications only.
Trunk Group - Specifies the name of the TDM Trunk Group on which the request must arrive at
the gateway in order to match the rule.