User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 157
Parameter Reference
3.17.0.7 Tone Frequency Deviation
Description: Specifies the deviation for the tone frequencies for this tone definition.
Allowed Values: 0-200 Hz
Default Value = 0
INI File Parameter Name = cpToneFreqDeviation
3.17.0.8 Tone Cadence Time
Description: Specifies the cadence times for this tone definition. A tone can be described by up to
three (3) cadence times.
The interpretation of each time parameter is dependent on the selection of Cadence Type. For a
given cadence type, Cadence Time specifies the time in milliseconds.
• Continuous - The first time value specifies the minimum time on that must elapse before the
tone on event is generated.
• OnOff - The first two time values are used to specify the on time and off time respectively.
• OnOffQuick - The first time value is used to specify the minimum on time that causes
detection and the second time value specifies the maximum off time that causes a cadence
break.
• Alternating - The first two time values specify the on time for the corresponding frequency
component.
• Sequential - For each of the tones in the sequence the corresponding time value specifies the
on-time for the tone.
Allowed Values: 0-10000 milliseconds
Default Value = 1500 milliseconds
INI File Parameter Name = cpToneTime
3.17.0.9 Tone Cadence Time Deviation
Description: Specifies the deviation for the cadence times for this tone definition.
Allowed Values: 0-1000 milliseconds
Default Value = 700 milliseconds
INI File Parameter Name = cpToneTimeDeviation