User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 15
Revision History
This revision history summarizes the changes made in each published version of this document.
Document No. Publication Date Description of Revisions
64-0346-12 November 2012 Updated to support Version 6.0 SU9 Software.
Chapter 1, “Overview” added new DMG2060DTISQV34 model listed under
DMG2000 section in Product Description.
Chapter 3, “Parameter Reference” added new parameter in Audio Group for Unhold
on RE-INVITE with No SDP.
Chapter 3, “Parameter Reference” added new parameters in Fax Group for Enable
V.34 Fax and V.34 Fax Speed Limit.
Chapter 3, “Parameter Reference” added new parameter in T.38 Fax Advanced
Settings for Fax TDM Drop Out Bridge Time (DMG2000 Only).
Chapter 3, “Parameter Reference” removed obsoleted parameter in T.38 Fax
Advanced Settings for Maximum UDPTL Packet Size.
Chapter 3, “Parameter Reference” added new parameter in Non-Menu (Hidden)
Parameters for Port Disable Timeout.
64-0346-11 September 2011 Updated to support Version 6.0 SU8 Software.
Chapter 3, “Parameter Reference” added new Serial Ports Group section with new
parameter for Maintenance Port Enabled.
Chapter 3, “Parameter Reference” added new parameter in User-Agent Group for
User-Agent Header Value.
Chapter 3, “Parameter Reference” added new User-User Information Group section
with new parameters for User-User Enabled and Translation Method.
Chapter 3, “Parameter Reference” added new ISUP Using Multipart MIME Group
section with new parameter for France Telecom’s IE77.
Chapter 3, “Parameter Reference” updated parameter Allowed Values for Telephony
Port Interface Side in T1/E1 Mode Group.
Chapter 3, “Parameter Reference” added new Rx/Tx Gain Control Group section with
new parameter for Analog Receive Gain.
Chapter 3, “Parameter Reference” added new parameter in T1/E1 Mode Group for
Clock Control.
Chapter 3, “Parameter Reference” added notes to parameter for Multiple Diversion
Processing in T1 ISDN Protocol Group (ISDN Signaling Mode).
Chapter 3, “Parameter Reference” added notes to parameter for
Multiple Diversion
Processing in E1 ISDN Protocol Group (ISDN Signaling Mode).
Chapter 3, “Parameter Reference” updated names of values for Optiset_300 to
Telephony Switch Type in TDM Digital Parameters to be more clear between North
American and European configurations.
Chapter 3, “Parameter Reference” updated parameter to Default Value = -43dBm for
Fax Modem Carrier Detect Threshold (DMG1000 Only) in T.38 Fax Advanced
Settings.
Chapter 5, “Routing Table” added more information to Select Primary / Alternate
Route in Inbound TDM Rules Table and Select Primary / Alternate Route in Inbound
VoIP Rules Table to show examples of failure that may occur before the call is
connected to the outbound destination.