Manualshelf

User`s guide

ManualsBrandsDialogic ManualsComputer equipment4000 Series SU4.1
131132133134135136137138139140
136 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Parameter Reference
3.11 TDM Port Enable Parameters
The TDM Port Enable parameters allow you to individually configure the call control capabilities
of each port connected to the Media Gateway. These parameters also allow you to enable or disable
individual ports. The TDM Port Enable group includes the following parameters:
• Port #
• Telephony Port Enabled
3.11.0.1 Port #
Description: This is a read-only parameter that defines the Media Gateway port numbers.
Note: If the T1/E1 signaling mode is configured for ISDN, the Port # refers to the T1 or E1 span number.
3.11.0.2 Telephony Port Enabled
Description: Specifies whether the telephony port is disabled or enabled. Disabled ports drop
communications links to the PBX.
Note: If the T1/E1 signaling mode is configured for ISDN, the Port # refers to the T1 or E1 span number.
Allowed Values:
• Yes = Port is enabled and is capable of providing a connection. The LED for this port may or
may not be green, depending on whether or not a line is plugged in.
• No = Port is disabled and is incapable of providing a connection. The LED for this port will be
red, regardless of whether or not a line is plugged in.
Default Value = Yes
INI File Parameter Name = telPortEnabled
3.12 TDM Call Type Group
The TDM Call Type group allows the user to specify the type of number for the called and calling
party information, which then can be sent to PBX to decide the call type. During a VoIP to ISDN
call, this call type information for called and calling party can be indicated to the PBX.
3.12.1 ISDN Call Type Rules
The Web interface contains two independent divisions for called and calling party rules. The
management interface will allow user to create multiple rules to set the call type for inbound and
outbound call numbers. The user can define rules to assign call type for each calling and called
party information for all outbound ISDN calls. Rules are evaluated from the top down until a
matching rule is found.
Figure 17 is a screen shot of the ISDN Call Type Rules Web page: