User`s guide

132 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Parameter Reference
3.9.4.3 CID to First Ring Timeout
Description: Specifies the number of milliseconds that are allowed from the end of the Type I
CPID on the first ring. If this time is exceeded, the CPID is cleared.
Note: This parameter is only needed when CPID arrives at the Gateway before the first ring. This
parameter can be ignored if the CPID arrives between the first and second ring.
Allowed Values: 500 to 30000 milliseconds
Default Value = 2000 milliseconds
INI File Parameter Name = telAlgPreRingDtmfTimeoutMs
3.9.4.4 Analog Interface Type
Description: Specifies the type of analog interface to which the DMG1000 is connected.
Allowed Values:
• PBX
• Central Office
Default Value = PBX
INI File Parameter Name = telAlgIfType
3.9.4.5 Central Office (Type I) Caller ID Type
Description: Specifies the Type I Caller ID modulation to use, either Bellcore FSK (North
America and Australia), DTMF (parts of Europe, including Sweden, Finland, Denmark,
Netherlands, and Iceland), or none. This configuration option is only enabled when the Analog
Interface Type is Central Office.
Note: If the Caller ID type is DTMF, then CPID parsing rules will need to be specified. See Chapter 6,
“Media Gateway Parsers” for further information on the creation and use of parsing rules.
Allowed Values:
• Bellcore FSK
• DTMF
• None
Default Value = None
INI File Parameter Name = telAlgCoCidType