User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 125
Parameter Reference
3.8.4.10 ISDN Answer Supervision Enable
Description: If ‘Yes’, and an outbound call receives a Progress Indicator with a 1 or 8 (non-ISDN,
inband), then the gateway will use in-band answer-supervision to determine when the call has been
answered. If ‘No’, then a received CONNECT message will be used to determine when the call has
been answered.
Notes: 1. Progress Indicator 1-Call is not end-to-end ISDN or may be in-band information.
2. Progress Indicator 8-Inband treatment has been applied.
Allowed Values:
• Yes
• No
Default Value = Yes
INI File Parameter Name = isdnAnswerSupervisionEnable
3.8.4.11 Enable Failover
Description: Specifies the Failover mode used when the gateway is powered down.
Note: This parameter is only applicable for DMG2060DTISQ and DMG2120DTISQ models.
Allowed Values:
• Yes = Failover enabled (span 1 to span 2) and (span 3 to span 4).
• No = Failover disabled (spans not interconnected).
Default Value = No
INI File Parameter Name = t1e1Failover
3.9 TDM Analog Parameters
The TDM Analog parameters only apply to the Models DMG1008LSW, DMG1004LSW. The
Analog parameters include the following subgroups:
• Timing Group
• Feature Code Group
• Message Waiting Control Group
• CPID Settings Group