User`s guide

Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide 105
Parameter Reference
3.7 TDM General Parameters
The TDM General Settings group includes the following parameters:
• PCM Coding
• Minimum Call Party Delay (Phone Emulating Only)
• Maximum Call Party Delay (Phone Emulating Only)
• Dial Digit On Time
• Dial Inter-Digit Time
• Dial Pause Time
• Turn MWI On FAC (Phone Emulating Only)
• Turn MWI Off FAC (Phone Emulating Only)
• Outbound Call Connect Timeout (Phone Emulating Only)
• Wait for Ringback/Connect on Blind Transfer (Phone Emulating Only)
• Hunt Group Extension (Phone Emulating Only)
• Disconnect on Fax Cleardown Tone
• Connect Outbound Call On DTMF
PCM Coding
Description: Sets the Media Gateway to the PCM coding mode used by the PBX.
Allowed Values:
• µLaw = PBX uses µLaw coding.
• aLaw = PBX uses ALaw coding.
Default Value = µLaw
INI File Parameter Name = dspPcmCoding
Minimum Call Party Delay (Phone Emulating Only)
Description: Specifies the minimum number of milliseconds that the Media Gateway will wait for
display information (calling party information) on an inbound PBX call before the call is routed to
the IP destination. (0 for no delay)
Allowed Values: 0 through 10000 milliseconds
Default Value = 0
INI File Parameter Name = telMinWaitForCpid