User`s guide

100 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Parameter Reference
RTP End Port
Description: Specifies the last UDP IP port used for Realtime Transport Protocol (RTP) traffic.
This value must be greater than the Start Port for RTP. It is recommended that this value be at least
1000 more than Start Port for RTP.
Allowed Values: 1024 to 65000
Default Value = 50000
INI File Parameter Name = gwRTPEndPort
Note: Unit requires a restart if this parameter value is changed.
RTP Source IP Address Validation
Description: If set to On, then the source IP address of received RTP packets must match the IP
address to which RTP is being sent. If the source IP address does not match, then the packet is
discarded. If set to Off, then the source IP address of received RTP packets is not validated.
Allowed Values:
• On
• Off
Default Value = Off
INI File Parameter Name = gwRTPValidateSrcIp
Note: Unit requires a restart if this parameter value is changed.
RTP Source UDP Port Validation
Description: If set to On, then the source UDP port of received RTP packets must match the UDP
port to which RTP is being sent. If the source UDP port does not match, then the packet is
discarded. If set to Off, then the source UDP port of received RTP packets is not validated.
Allowed Values:
• On
• Off
Default Value = Off
INI File Parameter Name = gwRTPValidateSrcPort
Note: Unit requires a restart if this parameter value is changed.