Product information guide

Dialogic
®
4000 Media Gateway Series Quickstart Guide
Page 4
General Safety Instructions
For general safety instructions, refer to the the Dell Product Information Guide, which is included with the
DMG4000 Gateway kit, and to the following:
WARNING • Never touch non-insulated telephone wires or terminals unless the telephone line
has been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Telephone companies report that electrical surges, typically lightning transients,
are very destructive to customer terminal equipment connected to AC power
sources. The use of a surge arrestor on the AC line is recommended.
Warning! Do not attempt to modify or use the supplied AC power cord if it is not
the exact type required.
Avertissement! Ne pas utiliser ni modifier le câble d'alimentation secteur fourni,
s'il ne correspond pas exactement au type requis.
Warnung! Versuchen Sie nicht, das mitgelieferte Netzkabel zu verändern oder zu
verwenden, wenn es sich nicht um genau den erforderlichen Typ handelt.
Avvertenza! Non modificare o utilizzare il cavo di alimentazione in c.a. fornito dal
produttore, se non corrisponde esattamente al tipo richiesto.
¡Advertencia! No intente modificar ni usar el cable de alimentación de corriente
alterna, si no corresponde exactamente con el tipo requerido.
• In some cases, the power cord supplied with this system may not be compatible
with the AC wall outlet in your region. If this is true, you must obtain a suitable
power cord that meets the following criteria:
• The cord must be rated for use at the AC voltage available, with a current rating
that is at least 125% of the current rating of the product (for current rating
information, refer to the regulatory label affixed to the product).
• The AC plug end must be terminated in a grounding-type male plug designed
for use in your region. The plug ends must be labeled or marked to indicate
they have been certified by an agency acceptable in your region.
• The power service must be connected through a properly grounded outlet.
• The connector at the product end must be an IEC 320, sheet C13, female
connector (or the equivalent EN 60 320 connector).
• The cord must be less than 14.8 feet (4.5 meters) long and, for use in Europe,
be created with <HAR> (harmonized) or VDE certified cordage.
• If power needs to be removed from this product, you must disconnect the
power cord; therefore, the socket-outlet shall be installed near the equipment
and shall be easily accessible.
INFORMATION • To help protect your gateway from transient increases and decreases in electrical
power, use a surge suppressor, line conditioner, or uninterruptible power supply
(UPS).
• Keep your gateway away from radiators and heat sources. Also, do not block
cooling vents.
Dialogic
®
Diva
®
PRI Media Boards
Cables for Interface ports used for the Dialogic
®
4000 Media Gateway Series shall
be shielded.