User's Manual

Table Of Contents

SC14CVMDECT SF Cordless Voice Module

9.3 PRECAUTIONS REGARDING UNINTENDED

COUPLING

Integration on the main board precautions shall be

taken in order to avoid any kind of

coupling from the main board to the RF part of the

module. If there is any doubt about this, a radio short

test should be performed.

9.4 END APPLICATION APPROVAL

The module is intended to be used in an end applica-

tion. Type approval concerning the end product, except

for the module, should off cause be done. Please con-

tact a test-house in order to clarify what is needed.

9.5 SAFETY REQUIREMENTS

This section provides of an overview of the safety

requirements you must adhere to when working with

the Cordless Voice Module SC14CVMDECT SF.

• The specific external power supply for the Cordless

Voice Module SC14CVMDECT SF has to fulfil the

requirements according to clause 2.5 (Limited power

source) of this standard EN 60950-1:2006.

• Interconnection circuits shall be selected to provide

continued conformance to the requirements of

clause 2.2 for SELV (Safety Extra Low Voltage) cir-

cuits according to EN 60950-1:2006 after making

connections.

• Interface type not subjected to over voltages (i.e.

does not leave the building).

• Requirements additional to those specified in this

standard may be necessary for:

• Equipment intended for operation in special envi-

ronments (for example, extremes of temperature,

excessive dust, moisture or vibration, flammable

gases and corrosive or explosive atmospheres).

• Equipment intended to be used in vehicles, on

Board ships or aircraft, in tropical countries or at

altitudes greater than 2000 m.

• Equipment intended for use where ingress of

water is possible.

• Installation by qualified personnel only!

• The product is a component intended for installation

and use in complete equipment. The final accept-

ance of the component is dependent upon its instal-

lation and use in complete equipment.