Data Sheet

DA14531MOD
SmartBond TINY
TM
Module
Preliminary
Datasheet
Revision 2.1
4-June-2020
CFR0011-120-00
26 of 31
© 2020 Dialog Semiconductor
End-product labelling
The DA14531 TINY MODULE is labelled with its own IC ID: 9576A-DA14531MOD. If the IC ID is not
visible when the module is installed inside another device, then the outside of the end-product into
which the module is installed must also display a label referring to the enclosed module. This exterior
label can use the following or similar wording: “Contains IC ID: 9576A-DA14531MOD”
11.4 MIC (JAPAN)
The DA14531 TINY MODULE has received type certification as required to conform to the technical
standards regulated by the Ministry of Internal Affairs and Communications (MIC) of Japan pursuant
to the Radio Act of Japan.
The module has been tested according to the following standard:
○ Radio: JRL “Article 49-20 and the relevant articles of the Ordinance Regulating Radio”
Equipment
End-product may need to follow additional requirement according to regulation EMC.
End-product labelling
The MIC ID can be applied directly on end-product's label. The end-product may bear the GITEKI
mark and certification number so that is clear that the end-product contains a certified radio module.
The following note may be show next to, below, above the GITEKI mark and certification number in
order to indicate the presence of a certified radio module:
当該機器には電波法に基づく、技術基準適合証明等を受けた特定無線設備を装着している。
Translation on the text:
“This equipment contains specified radio equipment that has been certified to the Technical
Regulation Conformity Certification under the Radio Law.”
11.5 NCC (Taiwan)
DA14531MOD-00F0100
The DA14531 TINY MODULE has received compliance approval in accordance with the
Telecommunications Act. The module has been tested according to following standard:
● Radio: Low Power Radio Frequency Devices Technical Regulations (LP0002)
End-product may need to follow additional requirement according to regulation EMC.
注意！
依據 低功率電波輻射性電機管理辦法