Data Sheet

DA14531MOD
SmartBond TINY
TM
Module
Preliminary
Datasheet Revision 2.1 4-June-2020
CFR0011-120-00 25 of 31 © 2020
Dialog Semiconductor
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
○ Reorient or relocate the receiving antenna.
○ Increase the separation between the equipment and receiver.
○ Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
○ Consult the dealer or an experienced radio/TV technician for help.
End-product labelling
The DA14531 TINY MODULE is labelled with its own FCC ID: Y82-DA14531MOD. If the FCC ID
is not visible when the module is installed inside another device, then the outside of the end-
product into which the module is installed must also display a label referring to the enclosed
module. This exterior label can use the following or similar wording:
“Contains FCC ID: Y82-DA14531MOD”
11.3 IC (CANADA)
IC ID: 9576A-DA14531MOD
The DA14531 TINY MODULE is certified for the IC as a single-modular transmitter. The module meets
IC modular approval and labelling requirements. The IC follows the same testing and rules as the FCC
regarding certified modules in authorized equipment.
The module has been tested according to following standards:
○ Radio: RSS-247 Issue 2: February 2017, RSS-Gen Issue 4: November 2014
○ Health: RSS-102 Issue 5:2015
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
RF Exposure Statement
This device complies with IC radiation exposure limits set forth for an uncontrolled environment and
meets RSS-102 of the IC radio frequency (RF) Exposure rules. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
Le présent appareil est conforme à l'exposition aux radiations IC définies pour un environnement non
contrôlé et répond aux RSS-102 de la fréquence radio (RF) IC règles d'exposition. L'émetteur ne doit
pas être colocalisé ni fonctionner conjointement avec à autre antenne ou autre émetteur.
OEM Responsibilities to comply with IC Regulations:
OEM integrator is responsible for testing their end-product for any additional compliance
requirements needed for the module installation like IC ES003 (EMC). This can be combined with
the FCC Part 15B test.