Datasheet

9
Colordriver™ RFCC
Connection Conditions
1W LEDs per Master Unit 18
1W LEDs per Slave Unit 18
No. of Slaves per Master Unit 100
Max. Cable Length to LEDs 10m
Max. Cable Length between Drive Units 30m
Total Circuit Cable Length 1km
Colordriver RF Remote Control Specification
Battery Voltage/Type AAA alkaline cell
Battery Life >30,000 keypresses
RF Frequency 433.92MHz
Modulation FM
Dimensions L96.0mm x W47.0mm x
H24.0mm
Operating Modes
Color Cycle
Fixed Color
On/Off
Two selectable memories
The Colordriver
™
RFCC is a three-channel
RGB LED driver, which combines an
intelligent power driver with an intuitive RF
remote control. Both masters & slaves can
drive up to 18 total 1W LEDs (3 channels
X6). Up to 99 slaves can be added per
master thus allowing control of up to 1800
LEDs with a single remote.
All Dialight Lumidrives Colordrivers come
with the “Lifesaver
™
” system which (when
used with “Lifesaver” equipped Dialight-
Lumidrives Colorengines) monitors PCB
temperature and automatically throttles back
the drive current should the system
overheat to ensure long LED lifetime.
Wall Mounted Control Unit
The control unit plugs directly into a slave
module giving the same functions as a
wireless remote. Additionally it can accept
an input from a DMX control system. In this
mode the front plate is disabled.
Order codes:
RFCC Master: CDURF-3-35
RFCC Slave: CDUSL-3-35
RFCC Remote: CDURF-TX
SL Control: CDUSL-CU
Dimensions: L179mm x W53mm x
H32mm
Weight: 163g