Datasheet

www.dialight.com
6
Mechanical, Electrical and Photometric information is the same
as on page 3 except where detail is provided
Variable Dimming Cable: Two conductor cable
Power Cable: Three conductor cable
Dimming Cable Position: Side of the neck through a cable gland
Variable Dimming Control: 0-10V DC active
Dimming Range: 10V DC = 100% light output
0V DC = 15% light output
DuroSite
®
LED High Bay
Variable Dimming (0-10V DC) & STEP Dimming High Bays
Dimensions in Inches [mm]
STEP Dimming Mode
The variable dimming High Bays may also be configured to operate in a
single STEP Dimming configuration. When the dimming control
conductors are connected together, the light output will be reduced to
approximately 15% of the maximum light output. The total fixture power
consumption will also be reduced to approximately 20% (30 W).
Connecting the leads together can be accomplished with a common wall
switch.
Features and Benefits
• 10’ plenum rated dimming control cable pre-installed
• Dimming cabling independent of fixture wiring
• Multiple High Bays can be connected to the same dimmer
• May also be configured to operate in a single STEP Dimming configuration