Datasheet

2-32
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: [phone] • FAX: [phone] •www.dialight.com
2.5mm Round
®
Optopipe
TM
Optical Light Pipe, 8 Array
515-1063
16.50
[.648]
18.03
[.71]
2.54
[.10]
8.13
[.320]
DIFFUSED FRONT
SURFACES
4.57
[.180] TYP
7 PLCS
34.55
[1.36]
Ø 2.50
[.098]
8 PLCS
10.40
[.41]
1.57
[.062]
12.70
[.050] SQR;
MNTG PINS
TYP ; 3 PLCS
13.72
[.540]
2 PLCS
2.794
[.11]
1.65
[.065]
2.69
[.1060]
TYP
1.70
[.067]
1.04
[.041]
TYP
Ø 1.60 ±.05
[Ø .064]±.002
TYP; 2 PLCS
4.57
[.180]
TYP
13.72
[.540 ±.08]
TYP; 2 PLCS
1.35
[.053]
TYP
2.21
[.087]
TYP
2.29
[.090]
4.39
[.173]
TYP
DIRECTION OF LIGHT
Dimensions in mm [inches]
Recommended
MicroLED SMT LEDs
for use with 515-1063
PART NO. PAGE #
597-3xx1-5xx 1-30
597-77x1-5xx 1-31
Solder Pad/Holes layout shown is for bi-color
LEDs
Contact factory for single color layout
Features
• Combines with Dialight’s 515-1062 Optopipe
TM
Light Pipe for bi-level
SMT indicators
• Suitable for high density arrays (.120 min array pitch)
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
• Arrays reduce insertion costs
• Secures to PCB by press-fit
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Dialight Optopipe Light Pipe Description
This Optopipe™ has 8 elements with a 2.5mm diameter placed on a narrow pitch. Although it is designed to be the
upper element of a bi-level array, it functions well as a single level array. An appearance similar to our 3mm bi-level 553
Series, arrays can be achieved by utilizing the 515-1062 for the lower level array. Three press-fit pins securely hold it in
place. The SMT LEDs are mounted in a straight line under the rear of the part on an 0.180" pitch. The light pipe material
is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C
NOTE: designed for
post-reflow
PC board insertion.
NEW