Datasheet

2-13
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: [phone] • FAX: [phone] •www.dialight.com
2
3.2mm Round
®
Optopipe
TM
Optical Light Pipe, 2 Array, Panel Mounted
515-1033
19.05
[.75]
REF
2.79
[.110] REF
.61
[.024]
.99
[.039] TYP
DIFFUSED
FRONT SURFACES
Ø 3.20
[.126]
2 PLACES
1.78
[.07]
4.57
[.18] TYP
(2) PLACES
13.97
[.550]
Ø 5.08
[.200]
(2) PLACES
4.32
[.17]
MAJOR DIA.
Ø 3.71 [0.146]
PRESS-FIT
RIBS
TYP, 3 PLCS
FRONT
PANEL
DIRECTION
OF LIGHT
.51
[.020]
MAX
TOP
SURFACE
OF LED
Dimensions in mm [inches]
LEDs for use with
515-1033
Recommended PAGE #
521-9247 6-44
521-9249 6-44
521-9251 6-44
550-xx10 6-17
550-5504 6-9
550-5505 6-11
550-5507 6-13
550-5508 6-15
550-5604 6-9
550-5605 6-11
550-5607 6-13
550-5608 6-15
550-5704 6-9
550-5705 6-11
550-5707 6-13
550-5708 6-15
Alternatives
521-9430 4-61
521-9431 4-61
521-9432 4-61
LED alternatives may not produce optimum light
output
Features
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
• Arrays reduce insertion costs
• Secures to panel by press-fit
(Also recommend supplement means of securing --
for example, clamping)
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Dialight Optopipe Light Pipe Description
This Optopipe™ is clamped to the inside of the plastic panel. The light pipe is not attached to the PCB at any point but
floats in front of it. The splines on the tubular section on the right hand side hold the light pipe in place for the clamping
operation. The funnel end faces the light source. The tubular sections fit through the plastic panel. The light emitting
surface is textured to diffuse the light passing through it. The light source can be any super-bright 2mm, 3mm, or 5mm
LED, or one of Dialight’s 597 Series SMT LEDs. The light source’s emitting surface should be located no more than
0.020" or 0.5mm from the Optopipe™. The light sources are mounted in a straight line facing the rear of the light pipe on a
14mm pitch. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen
index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C
NEW