Datasheet

2-51
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: [phone] • FAX: [phone] •www.dialight.com
2
3mm Square
®
Optopipe
TM
Optical Light Pipe, Quad High
515-1023-803
4.95
[.195]
5.16
[.203]
4.95
[.195]
4.95
[.195]
5.31
[.209]
3.53
[.139]
21.59
[.850]
3.18
[.125]
3.20
[.126]
.76
[.030]
REF.
.99
[.039]
.51
[.020]
.99
[.039]
2.01
[.079]
1.24
[.049]
4.45
[.175]
9.07
[.357]
13.34
[.525]
RECOMMENDED PIN HOLES AND SOLDER PAD
LAYOUT FOR SUGGESTED MicroLED LEDs
COMPONENT SIDE OF PRINTED CIRCUIT BOARD
Direction
of Light
4.31
[.170]
8.23
[.324]
[.116 DIA] TYP
.
(2) PLACES
4.12
[.162]
28.75
[1.132]
19.69
[.775]
6.02
[.237]
4.45
[.175]
4.45
[.175]
NOTE:
C.L. of LED
4.45
[.175]
Ø [.113 ± .002]
LIGHTSHIELDS
2 PLCS
Dimensions in mm [inches]
NOTE: designed for
post-reflow
PC board insertion.
Recommended
MicroLED SMT LEDs
for use with 515-1023-803
PART NO. COLOR PAGE #
597-3001-1xx Red 1-19
597-3111-1xx AlGaAs Red 1-19
597-3211-1xx Orange 1-19
597-3301-1xx Green 1-19
597-3401-1xx Yellow 1-19
597-7701-1xx Red/Green 1-20
597-7721-1xx Yellow/Green 1-20
597-7731-1xx Red/Yellow 1-20
Features
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
• Arrays reduce insertion costs
• Allows quad level SMT indicators
• Secures to PCB by press-fit
LED Data
For absolute maximum ratings and other
electrical and optical data on the recommended
LEDs, refer to LED data sheets.
Dialight Optopipe Light Pipe Description
This Optopipe™ has a relatively low vertical height considering the number of light pipe elements. The element’s
square emitting surfaces are vertically spaced 0.203" from the PCB to the first element, and then 0.195" between each of
the other elements. This Optopipe™ is held in place by 2 press-fit pins on the bottom of the device. The wide base offers
added stability to the installed part. The light pipe is not attached to the panel at any point, but protrudes through holes in
the panel. This Optopipe™ was specifically designed to accept Dialight’s 597 Series Type 1210 LEDs. The light pipe
material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C
NEW