Datasheet

2-56
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: [phone] • FAX: [phone] •www.dialight.com
2.5 x 5mm Rectangular
®
Optopipe
TM
Optical Light Pipe
515-1004
1.27
[.050]
5.03
[.198]
6.91
[.272]
2.49
[.098]
7.57
[.298]
1.27
[.050]
6.60
[.260
]
3.25
[.128]
4.93
[.194]
9.65
[.380]
5.86
[.231]
Ultrasonic
Weld Detail
C.L. of
LED
NOTE:
Designed for front panel mounting
DIRECTION
OF LIGHT
Dimensions in mm [inches]
Recommended
MicroLED SMT LEDs
for use with 515-1004
PART NO. COLOR PAGE #
597-3111-4xx AlGaAs Red 1-28
597-3201-4xx Orange 1-28
597-3311-4xx Green 1-28
597-3401-4xx Yellow 1-28
Features
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
• Diffused lens
• Secures to front panel by ultrasonic welding
LED Data
For absolute maximum ratings and other
electrical and optical data on the recommended
LEDs, refer to LED data sheets.
Dialight Optopipe Light Pipe Description
This Optopipe™ is ultrasonically welded to the customer’s plastic housing using the tab at the top of the part. The light
pipe is not attached to the PCB at any point, but floats above it. The light emitting surface is textured to increase its
viewing angle. The selection of a suitable LED light source is left to the customer’s discretion. However, reflector type light
sources like our 597 Series PLCC-2 or PLCC-4 Type SMT LEDs are good choices. The light pipe material is water clear
transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C
NEW