Instructions / Assembly

ASSEMBLY INSTRUCTIONS
Up-Dux® Ceiling-To-Attic Vent – Extended Height Top-R™ Model
1. Slide the upper sleeve section up and out of the lower sleeve section (upper and lower sleeve sections are telescoped together inside of the package).
Place the lower sleeve section on a smooth/level surface.
2. With the labeled side of the lower sleeve section facing you, hang the four cradle brackets in position on the inside top edges of the lower sleeve section
side-panels. The pre-drilled holes on each cradle bracket should be aligned with the corresponding holes on the side-panels.
3. Carefully place the upper sleeve section into position on the inside flanges of hanging cradle brackets. As illustrated above, the labeled sides of the
upper and lower sleeve sections should both be on the same side of the assembled vent sleeve. The pre-drilled holes on all four side-panels of the
upper and lower sleeve sections should be aligned with the corresponding holes on the cradle brackets.
4. Secure the upper and lower sleeve sections to one another using ¼“ sheet metal screws.
© 2010 Dial Manufacturing, Inc.
www.dialmfg.com
Form 97650-0210