User`s manual

USER'S MANUAL 5750210
Revision B Section H, Page 4
Troubleshooting the I.V./700 H1-3
Q11 The I.V./700 is printing the correct message
but ink dots are missing from some of the
characters. Why?
S11 The faceplate of the printhead is dirty and some
of ink jet orifices are blocked. Clean the
faceplate with water and purge the printhead. If
any of the ink jet orifices remain blocked, then
remove the obstruction using a Broach Kit (1902-
857).
Q12 The I.V./700 is printing the correct message
but the ink dots are too small. Why?
S12 The dot size is too small. Increase the dot size
by following the directions on instruction page
C4.
Q13 The I.V./700 is printing the correct message
but the characters are out of position and
there are a lot of extra dots. Why?
S13 The printhead is too far from the product. Adjust
the printhead until it is closer to the box. The
faster the box travels the closer the printhead
must be to the box.
Q14 After sitting idle for a few minutes, the dots in
the in the first message are too small when
the I.V./700 starts printing again. Why?
S14 Undersized dots on startup can result from two
adjustments: dot size and print delay. These
variables need to be tested and set at the same
time to achieve a satisfactory solution. Adjust
the size of the first printed dots and the print
delay by following the directions on instruction
page C9.
Q14 I selected fixed speed and now my I.V./700
prints random dots Why?
S14 The I.V./700 print direction is wrong. Change the
print direction by following the directions on
instruction pages F8.