User`s manual

USER'S MANUAL 5750210
Revision B Section H, Page 3
Troubleshooting the I.V./700 H1-2
Unsatisfactory Print, Questions and Solutions
Q6 The I.V.700 is not printing even though all of
the LED’s are working normally.
S6 Remove the four Phillips screws from the
controller housing and check the cable
connection between the printhead cable and the
controller board.
Q7 All indications are normal but the I.V./700
prints on every other box. Why?
S7 The Photocell Off distance is longer than the
length of the product. Decrease the Photocell Off
distance by following the directions on instruction
page F5.
Q8 The I.V./700 is printing normally but it’s the
wrong message. Why?
S8 The wrong message has been selected to print.
Follow the directions on instruction page A1 and
select another message to print.
Q9 The I.V./700 is printing the correct message
but the message is too far to one side. Why?
S9 The message indent distance is incorrect. Adjust
the distance by following the directions on
instruction pages C1 and C2.
Q10 The I.V./700 is printing normally but the
message is too wide. Why?
S10 The character width is too big or too narrow.
Perform one of the following procedures:
[1] Shorten or widen the character width by
following the directions on instruction page
C3.
[2] Increase or decrease the fixed speed by
following the directions on instruction page
F6.