User`s manual

USER'S MANUAL 5750210
Revision B Section F, Page 14
Using the External Photocell Model F10
These instructions cover the configuration of the I.V./700 with the external photosensor
Setting the controller for the external photosensor requires accessing a menu that is available only after
a special initialization. DO NOT USE THIS MENU option if you are using the standard I.V./700 and its
built-in photosensors. Start by unplugging the I.V./700
1 Press and hold ALT and
INFORMATION.
2 Plug in the cannon connector.
3 Release the keys when the LCD
shows “Information”.
4 Press SET-UP.
5 Press L on the QWERTY keypad.
The LCD will prompt for an external
photocell.
6 Press 2 and then ENTER. The LCD
will prompt for a fixed print speed.
7 Type in a print speed and then
ENTER. The LCD will prompt for a
fixed print direction.
8 Select the print direction and press
ENTER.
Information
1-Unused Messages
External Photocell?
1-No 2-Yes :1
Print Speed:
040.0 ft/min
Fixed Direction:
1:<
---
2:
---
> :2