User`s manual

USER'S MANUAL 5750210
Revision B Section C, Page 12
Sizing Dots in Columns C11
When the I.V./700 prints a single dot, the printing channel has individual access to ink pressure. When all
seven channels print simultaneously, they share the ink pressure. This sharing can produce printed dots in
columns that are slightly smaller in diameter than single printed dots. The column dot adjustment enables
you to eliminate slight size variances between dots printed in rows and dots printed in columns.
Column dot adjustment requires a menu that is available only after a special initialization. Start by
unplugging the I.V./700.
1 Press and hold ALT and INFORMATION.
2 Plug in the barrel connector.
3 Release the keys when the LCD shows
“Information.”
4 Press SET-UP
5 Press I on the QWERTY keypad. The
LCD will prompt for a change in value of
the column dot adjustment:
6 Scroll to a higher or lower number.
7 Press ENTER.
8 Run a print sample at the speed of a production run.
9 Continue adjusting until the dots in columns match the size of dots printed in rows.
The scanned samples below show the adjustments that can be made to dots in columns.
Information
1-Unused Messages
Column Dot Adjust:
3
Dots with column
adjustment set too low
Nominal letters
Dots with column
adjustment set too high