User's Manual

www.diablopaintball.com

PAINTBALL

Numbers shown in parentheses following part names correspond to the

numbers on the Parts key located on the centerfold pages of this manual.

INITIAL ASSEMBLY

1. Screw Barrel (23) hand tight into the Main Body (34) making sure the

Barrel O-Ring (16) is properly seated between the Barrel and the

Main Body to prevent the Barrel from vibrating loose during rapid firing.

2. Screw Volumizer (26) hand tight into the Vertical ASA (33) making

sure a Multi-use O-Ring (16) is properly seated between the Volumizer

and the Vertical ASA to properly seal this connection.

3. Screw Velocity Adjuster (12) into the Hammer Plug (24) approximately

2 complete turns.

4. Insert the Barrel Plug into the end of the Barrel (23).

BATTERY INSTALLATION

1. Find the On/Off switch located on the left side of the marker just above

the Left Grip Panel (36).

2. Make sure the switch is in the “Off” position which is toward the rear of

the marker.

3. Using a screwdriver remove the three Grip Panel Screws (20) from the

left side (side facing you if the barrel is pointing to your left) of the Grip

Panel (36).

4. Install 9 volt battery.

5. Push the On/Off switch forward towards the “On” position.

6. Confirm that the LED light located on the grip is lit to signify that the

battery is good and properly installed.

7. Push the On/Off switch forward towards the “Off” position.

8. Replace Grip Panel using the three Grip Panel Screws, being careful not

to pinch the wires leading to the battery connector and those leading to

the circuit board.

ATTACHING PROPELLANT SOURCE

1. Confirm that Barrel Plug is properly installed.

2. Cock the marker by pulling the Bolt Pull Pin (28A) in the rearward

direction until it “clicks” into place. This compresses the Main Spring (2)

and allows the Valve Stem/Seal (7) to properly seat.

3. Confirm that the On/Off switch is in the “Off” position

4. Point the marker downward and in a safe direction.

5. Place the leading end of the propellant cylinder threads into the

threaded interface of the Tank Adapter (14).

DiabloMongooseManInside2.qxd 10/14/04 2:03 PM Page 4