User's Manual

www.diablopaintball.com
PAINTBALL
CHRONOGRAPHING
Never operate your marker without first checking the velocity and
confirming that you are firing below that required on the field of play.
At no time should the marker fire paintballs in excess of 300 feet per
second. Higher velocities are not only potentially dangerous, they
often result in a substantial increase in paintballs broken in the
marker.
1. Confirm that Barrel Plug is properly installed, the On/Off switch is
in the “Off” position and the Bolt Pull Pin is cocked to the rear.
2. Using a 5/64 hex key make sure the Locking Set Screw (12B) is
backed out without removing it.
3. Make sure that you and anyone within range is wearing eye
protection designed specifically for paintball.
4. While pointing the paintball marker in a safe direction, remove the
barrel plug and move the On/Off switch to the “On” position.
5. Point the marker over the chronograph and in a safe direction.
6. Pull the trigger and observe the reading on the chronograph.
7. To increase the velocity, turn the Velocity Adjuster (12) clockwise.
8. To decrease the velocity, turn the Velocity Adjuster counter-clock
wise.
9. Once the desired velocity has been reached, use the 5/64 hex
key to turn the Locking Set Screw in until it binds against the
Hammer Plug. This will prevent the velocity adjuster from moving
during play and is required on most playing fields.
10. Move the On/Off switch to the “Off” position.
11. Insert Barrel Plug
12. Proceed to playing field.
13. Keep the On/Off switch in the “Off” position and barrel plug in
place until ready to play and instructed to remove the barrel plug
by a playing field staff member.
8.
DiabloMongooseManInside2.qxd 10/14/04 2:03 PM Page 8