User's Manual

www
.diablopaintball.com
PAINTBALL
.68 CALIBER ELECTRONIC PAINTBALL MARKER
Meets or exceeds ASTM standards.
Adjusting the Rate-of-Fire
1. Point the marker in a safe direction
2. Make sure the barrel blocking device is properly installed.
3. Press and release the Adjustment Button to change the rate of fire (see
table 1 for LED representation of firing rates).
Eyes On/Off
20 BPS
16 BPS
12 BPS
10 BPS
8 BPS
6 BPS
Table 1
Turning On the Safety (powering down the marker)
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction
3. Make sure the barrel blocking device is properly installed.
4. Press and hold Command Button 5 seconds until all LEDs go off.
5. The marker is now OFF.
BATTERY INSTALLATION
1. Find the On/Off switch located on the left side of the marker just above
the Left Grip Panel (36).
2. Make sure the switch is in the “Off” position which is toward the rear of
the marker.
3. Using a screwdriver remove the three Grip Panel Screws (20) from the
left side (side facing you if the barrel is pointing to your left) of the Grip
Panel (36).
4. Install 9 volt battery.
5. Push the On/Off switch forward towards the “On” position.
6. Confirm that the LED light located on the grip is lit to signify that the
battery is good and properly installed.
7. Push the On/Off switch forward towards the “Off” position.
8. Replace Grip Panel using the three Grip Panel Screws, being careful not
to pinch the wires leading to the battery connector and those leading to
the circuit board.
ATTACHING PROPELLANT SOURCE
1. Confirm that Barrel Plug is properly installed.
2. Cock the marker by pulling the Bolt Pull Pin (28A) in the rearward
direction until it “clicks” into place. This compresses the Main Spring (2)
and allows the Valve Stem/Seal (7) to properly seat.
3. Confirm that the On/Off switch is in the “Off” position
4. Point the marker downward and in a safe direction.
5. Place the leading end of the propellant cylinder threads into the
threaded interface of the Tank Adapter (14).
6. Without pushing, twist the propellant cylinder in a clockwise direction
and allow the cylinder threads to “draw” it into the Tank Adapter.
DO NOT force the cylinder which could cause cross threading.
7. Screw the propellant cylinder completely in until it is firmly seated.
ATTACHING FEEDER/ HOPPER
Due to the extremely high rate of fire capability of this marker, we highly recommend the
use of a motorized hopper such as the Diablo TSA or Empire Reloader B.
1. Confirm that Barrel Plug is properly installed and the On/Off
switch is in the “Off” position
2. Twist the Clamp Feed Adjustment (11A) in a counter-clockwise
direction until it is loose but do not remove. If accidentally
removed, screw back on one complete turn.
3. Press neck of Feeder/Hopper into the Vertical Feed Neck (11)
until completely seated.
8. 9.