User's Manual

www
.diablopaintball.com
PAINTBALL
.68 CALIBER ELECTRONIC PAINTBALL MARKER
Meets or exceeds ASTM standards.
Numbers shown in parentheses following part names correspond to the
numbers on the Parts key located on the centerfold pages of this manual.
INITIAL ASSEMBLY
1. Screw Barrel (23) hand tight into the Main Body (34) making sure the
Barrel O-Ring (16) is properly seated between the Barrel and the
Main Body to prevent the Barrel from vibrating loose during rapid firing.
2. Screw Volumizer (26) hand tight into the Vertical ASA (33) making
sure a Multi-use O-Ring (16) is properly seated between the Volumizer
and the Vertical ASA to properly seal this connection.
3. Screw Velocity Adjuster (12) into the Hammer Plug (24) approximately
2 complete turns.
4. Insert the Barrel Plug into the end of the Barrel (23).
LED OPERATIONS
Powering up
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction
3. Make sure the barrel blocking device is properly installed.
4. Press and hold Command Button 5 seconds until LEDs light up. LEDs
will light in order and then turn off in reverse order. The marker is now
on but in Safe mode.
Turning off the Safety
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction
3. Make sure the barrel blocking device is properly installed.
4. With LEDs lighting in order and then turning off in reverse order, press
and release Command Button.
CAUTION: The marker is now ready to fire.
Turning Off the Eyes
1. Point the marker in a safe direction
2. Make sure the barrel blocking device is properly installed.
3. With the marker powered up and off Safe, press and release Command Button.
4. The top LED (green) will go out, this indicates that the marker's anti-
chop eyes are off.
Note: You will need to turn the eyes off to allow cycling of the marker without
paintballs.
CAUTION: DO NOT use the anti-chop eyes as a safety device.
Turning on the Eyes
1. Point the marker in a safe direction
2. Make sure the barrel blocking device is properly installed.
3. With the marker powered up and off Safe, press and release Command
Button.
4. The top LED (green) will turn on, this indicates that the marker's anti-
chop eyes are on.
Note: You will need to turn the eyes off to allow cycling of the marker without
paintballs.
CAUTION: DO NOT use the anti-chop eyes as a safety device.
Preparing to Change Rate-of-Fire
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction
3. Make sure the barrel blocking device is properly installed.
4. Using a Phillips head screw driver, remove the tournament cover to the
Adjustment Button.
4. 5.