user manual TM TM www.diablopaintball.com .68 CALIBER ELECTRONIC PAINTBALL MARKER Meets or exceeds ASTM standards.
TABLE OF CONTENTS: Page Topic(s) 1 Warning and Rules Safe Marker Handling Warranty Information Welcome Initial Assembly Parts Key Exploded Diagram Battery Installation Attaching Feeder/Hopper Attaching Propellant Source Chronographing Loading Paintballs De-Gassing Maintenance Storage Trouble Shooting Guide Notes Warranty Registration 2 3 4 6 7 8 9 10 11 12 13 14 15 17 WARNING: This is not a toy. Misuse may cause serious injury or death.
WARRANTY INFORMATION STANDARD WARRANTY: The manufacturer warranties to the original customer that this product is free from defects in material and workmanship under normal use and service for a period of 90 days from the original date of purchase by the initial owner/purchaser. The manufacturer agrees to repair or replace (at its discretion) any product within a reasonable period of time.
Numbers shown in parentheses following part names correspond to the numbers on the Parts key located on the centerfold pages of this manual. INITIAL ASSEMBLY 1. 2. 3. 4. Screw Barrel (23) hand tight into the Main Body (34) making sure the Barrel O-Ring (16) is properly seated between the Barrel and the Main Body to prevent the Barrel from vibrating loose during rapid firing.
16 25A 33 16 25 Meets or exceeds ASTM standards. .68 CALIBER ELECTRONIC PAINTBALL MARKER TM 26 Part Name Hammer Main Spring Recoil Pad Spring Strut Quick Strip Pin A. Cotter Pin Gas Valve Cup Seal Valve Spring Valve Gas Plug Valve Stop Pin Vertical Feed Neck A. ClampFeed Adjustment Velocity Adjuster A. Anti-Vibration O-Ring B. Locking Set Screw Ball Detent Tank Adapter A.
Adjusting the Rate-of-Fire 1. Point the marker in a safe direction 2. Make sure the barrel blocking device is properly installed. 3. Press and release the Adjustment Button to change the rate of fire (see table 1 for LED representation of firing rates). 4. 5. 6. 7. 8. Eyes On/Off 20 BPS ATTACHING PROPELLANT SOURCE 16 BPS 1. 2. 12 BPS 10 BPS 8 BPS 3. 4. 5. 6 BPS Table 1 Turning On the Safety (powering down the marker) 1.
4. 5. Orient the Feeder/Hopper so that the lid is facing the rear of the marker and the Feeder/Hopper is parallel to the Main Body (34). Twist Vise Ring in a clockwise direction until it fits snugly against the Feeder/Hopper neck. LOADING PAINTBALLS 5. 6. 7. 8. 9. The performance of your marker is directly related to the quality of paintballs used. We highly recommend Diablo paintballs to give you satisfaction and success on the playing field. 1. 2.
10. Pull the trigger and allow the marker to cycle to confirm the absence of paintballs in the marker’s breech. If a ball discharges, repeat until no more paintballs come out of the marker. Cleaning/ Lubricating/ Assembly 1. 2. 3. WARNING: When removing the cylinder from the marker, it could fly off with enough force to kill if the valve unscrews from the cylinder. LOOK at valve when removing cylinder. STOP if valve starts to unscrew from the tank.
TROUBLE SHOOTING GUIDE: NOTES ON MONGOOSE: Symptom Cause Cure Does not Fire Not Cocked Cock the Bolt Pull Pin (28A) to the rear.
NOTES ON MONGOOSE: WARRANTY REGISTRATION: To assist us in providing the best customer service possible and to increase your warranty from 90 days to one year at no additional cost Complete and mail this to: Paintball Solutions 570 Mantua Blvd. Sewell, NJ 08080 Or register online at www.paintballsolutions.