User's Manual

www
.diablopaintball.com
PAINTBALL
.68 CALIBER ELECTRONIC PAINTBALL MARKER
Meets or exceeds ASTM standards.
Turning OFF the Battery saver
1. With the LCD screen reading:
POWER
AUTO
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release Adjustment Button screen will read:
POWER
ON
(Flashing)
5. Press and release the Command Button.
Note: The marker will not automatically shut off in this mode.This is not recom-
mended unless you are playing in unusual circumstances where you will not fire
for several minutes and do not want the marker to shut off.
Turning the Eyes off
1. With the LCD screen reading:
EYES
ON
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release Command Button screen will read:
EYES
OFF (Flashing)
6. Press and release the Command Button.
Note: You will need to turn the eyes off to allow cycling of the marker with-
out paintballs.
Turning on the Safety
(powering down the marker)
6. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
7. Point the marker in a safe direction.
8. Make sure the barrel blocking device is properly installed.
9. Press and hold Command Button 5 seconds until screen goes blank.
10. The marker is now OFF.
ATTACHING PROPELLANT SOURCE
1. Confirm that Barrel Plug is properly installed.
2. Cock the marker by pulling the Bolt Pull Pin (28A) in the rearward
direction until it “clicks” into place. This compresses the Main Spring (2)
and allows the Valve Stem/Seal (7) to properly seat.
3. If the LCD is powered on, press and hold the On/Off Button until the
LCD goes out.
4. Point the marker downward and in a safe direction.
5. Place the leading end of the propellant cylinder threads into the
threaded interface of the Tank Adapter (14).
6. Without pushing, twist the propellant cylinder in a clockwise direction
and allow the cylinder threads to “draw” it into the Tank Adapter.
DO NOT force the cylinder which could cause cross threading.
7. Screw the propellant cylinder completely in until it is firmly seated.
ATTACHING FEEDER/ HOPPER
Due to the extremely high rate of fire capability of this marker, we highly recommend the
use of a motorized hopper such as the Diablo TSA or Empire Reloader B.
1. Confirm that Barrel Plug is properly installed and, if the LCD is powered
on, press and hold the On/Off Button until the LCD goes out.
2. Twist the Clamp Feed Adjustment (11A) in a counter-clockwise direction
until it is loose but do not remove.If accidentally removed, screw back
on one complete turn.
3. Press neck of Feeder/Hopper into the Vertical Feed Neck (11) until
completely seated.
4. Orient the Feeder/Hopper so that the lid is facing the rear of the marker
and the Feeder/Hopper is parallel to the Main Body (34).
5. Twist Vise Ring in a clockwise direction until it fits snugly against the
Feeder/Hopper neck.
LOADING PAINTBALLS
The performance of your marker is directly related to the quality of paintballs used.We highly
recommend Diablo paintballs to give you satisfaction and success on the playing field.
1. Confirm that Barrel Plug is properly installed and, if the LCD is powered
on, press and hold the On/Off Button until the LCD goes out.
8. 9.