User's Manual

www
.diablopaintball.com
PAINTBALL
.68 CALIBER ELECTRONIC PAINTBALL MARKER
Meets or exceeds ASTM standards.
Battery Saver
1. With the LCD screen reading:
TIMER
00:00
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release Command Button screen will read: POWER AUTO
This indicates that the marker will automatically shut down after 30 minutes if not fired.
Eyes
1. With the LCD screen reading:
POWER
AUTO
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release Command Button screen will read:
EYES
ON
This indicates that the marker’s anti-chop eyes are on. This usually prevents the
marker from cycling unless a ball is properly chambered.
CAUTION: DO NOT use the anti-chop eyes as a safety device.
Turning on the safety (powering down the marker)
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and hold Command Button 5 seconds until screen goes blank.
5. The marker is now OFF.
Preparing to Change Settings
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Using a Phillips head screw driver, remove the tournament cover to the
Adjustment Button.
Adjusting the Rate-of-Fire
1. With the LCD screen reading:
SEMI 04
000000
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release the Adjustment Button one time for each additional
ball-per-second you wish to raise the rate of fire. The minimum firing
rate is: SEMI 04. The maximum firing rate is: SEMI 20
5. Once the desired firing rate is shown on the LCD screen, press and
release the Command Button to save the firing rate setting.
Resetting the Shot counter
1. With the LCD screen reading:
COUNTER
000000
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and hold Adjustment Button screen will read:
COUNTER 000000
5. Once the shot counter is reset, press and release the Command Button.
Adjusting the Timer
1. With the LCD screen reading:
TIMER
00:00
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press the Adjustment Button until screen displays desired number of
minutes to countdown
5. Once the countdown timer shows the desired time, press and release
the Command Button.
6. 7.