User's Manual

www
.diablopaintball.com
PAINTBALL
.68 CALIBER ELECTRONIC PAINTBALL MARKER
Meets or exceeds ASTM standards.
Numbers shown in parentheses following part names correspond to the
numbers on the Parts key located on the centerfold pages of this manual.
INITIAL ASSEMBLY
1. Screw Barrel (23) hand tight into the Main Body (34) making sure the
Barrel O-Ring (16) is properly seated between the Barrel and the
Main Body to prevent the Barrel from vibrating loose during rapid firing.
2. Screw Volumizer (26) hand tight into the Vertical ASA (33) making
sure a Multi-use O-Ring (16) is properly seated between the Volumizer
and the Vertical ASA to properly seal this connection.
3. Screw Velocity Adjuster (12) into the Hammer Plug (24) approximately
2 complete turns.
4. Insert the Barrel Plug into the end of the Barrel (23).
INITIAL BATTERY INSTALLATION
1. Be sure to fully charge the 9.6 volt battery that is packaged with this
marker.
2. Using a Phillips head screw driver, remove the three grip panel screws
(20) from the left side of the grip panel.
3. Remove the grip panel.
4. Being careful not to pinch or strain the wiring harness, install the fully
charge 9.6 volt battery supplied with this marker.
5. Replace the grip panel.
6. Reinstall the three grip panel screws (20).
LCD OPERATIONS
Powering Up
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and hold Command Button 5 seconds until screen reads:
BOOTING
SAFE
Turning OFF the Safety
1. Make sure that you and anyone within range are wearing eye protection
designed specifically for paintball.
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release Command Button screen will read:
SEMI 04 000000
5. The first line means the marker is set to cycle each time the trigger is
pulled and released with a maximum cycling rate of 04 balls-per-second.
The second line refers to the total number 000000 of shots that have
been fired from this marker since the last time the counter was reset.
CAUTION: The marker is now ready to fire.
Shot Counter
1. With the LCD screen reading: SEMI 04 000000
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release Command Button screen will read:
COUNTER
000000
This is the marker’s shot counter indicating the number of cycles the marker has
completed since the counter was last reset.
Timer
1. With the LCD screen reading:
COUNTER
000000
2. Point the marker in a safe direction.
3. Make sure the barrel blocking device is properly installed.
4. Press and release Command Button screen will read: TIMER 00:00
This is the marker’s countdown timer indicating the setting of the countdown timer.
4. 5.