User's Manual
Loading Paintballs
The performance of your marker is directly related to the quality of paintballs
used. We highly recommend Diablo paintballs to give you the most satisfaction
and success on the playing field.
1. Confirm that Barrel Blocking Device is properly installed and the
LCD says “BD 5”.
2. Point marker in a safe direction and load paintballs in the Feeder/Hopper. If you
are using a non-motorized hopper, be sure to leave some room in the hopper for
the balls to feed properly.
Deactivating Safety
1. Make sure that you and anyone within range is wearing eye protection designed
specifically for paintball.
2. Confirm that Barrel Blocking Device is properly installed and the
LCD says “BD 5”.
3. Look at the LCD while pushing the button.
4. The screen will now read “Semi 15” on the top line with “000000” underneath. It
is possible that there will be numbers other than “0” on the bottom line. These
are shot counts.
5. The Wrath is now live.
Chronographing
Never operate your marker without first checking the velocity and confirming that
you are firing below that required on the field of play. At no time should the
marker fire paintballs in excess of 300 feet per second. Higher velocities are not
only potentially dangerous, they often result in a substantial increase in paint
balls broken in the marker.
1. Make sure that you and anyone within range is wearing eye protection designed
specifically for paintball.
2. Point the marker over the chronograph and in a safe direction.
3. Pull the trigger and observe the reading on the chronograph.
4. Using a 7/32 hex key adjust Vertical Regulator (VR) until pressure gauge reads
about 200 psi. You may need to fire the marker after each adjustment to allow
the gauge to adjust.
5. To increase the velocity, adjust the VR clockwise.
6. To decrease the velocity, adjust the VR counter-clockwise.
7. Replace the Barrel Blocking Device.
8. Hold down the button until the LCD blinks “Safety”.
9. The Wrath is now on Safe.
10. Keep the Wrath on Safe and Barrel Blocking Device in place until ready to play
and instructed to remove the Barrel Blocking Device by a playing field staff
member.
5.
Meets or exceeds ASTM standards.
5-8-6-7.qxd 1/10/05 10:29 AM Page 2