User's Manual

BATTERY INSTALLATION
1. Properly position barrel blocking device to prevent accidental discharge.
2. Using a 2.5mm hex wrench, remove the three Grip Panel Screws from the left
side (side facing you if the barrel is pointing to your left) of the Grip Panel.
3. Install 9 volt battery.
4. Replace Grip Panel Screws.
POWERING ON
1. Confirm that Barrel Blocking Device is properly installed.
2. Look at the LCD while pushing the button and holding until the solid line
disappears and is replaced by “BD 5 with “*******” underneath.
3. Release On/Off switch.
4. The Wrath is now “On” in “Safe Mode”
ATTACHING PROPELLANT SOURCE
1. Confirm that Barrel Blocking Device is properly installed.
2. Confirm that the LCD says “BD 5”.
3. Point the marker downward and in a safe direction.
4. Place the leading end of the propellant cylinder threads into the threaded inter
face of the (Air Source Adapter) “ASA”.
5. Without pushing, twist the propellant cylinder in a clockwise direction and allow
the cylinder threads to “draw” it into the ASA. DO NOT force the cylinder which
could cause cross threading.
6. Screw the propellant cylinder completely in until it is firmly seated
ATTACHING FEEDER/HOPPER
Due to the extremely high rate of fire capability of the Wrath, we highly recom-
mend the use of a motorized hopper such as the Diablo TSA, Empire Reloader,
or Empire Reloader B.
1. Confirm that Barrel Blocking Device is properly installed and the
LCD says “BD 5”.
2. Twist Vise Ring in a counter-clockwise direction until it is loose but do not
remove. If accidentally removed, screw back on one complete turn.
3. Press neck of Feeder/Hopper into the Direct Feed (4) until completely seated.
4. Orient the Feeder/Hopper so that the lid is facing the rear of the
marker and the Feeder/Hopper is parallel to the Receiver.
5. Twist Vise Ring in a clockwise direction until it fits snugly against the
Feeder/Hopper neck.
4.
diablopaintball.com
3-10-4-9.qxd 1/10/05 10:27 AM Page 3