Instruction Manual

8 9
Product Specifications
Power Consumption
62 Watts
Input Voltage
100-240 VAC 50/60 Hz
Operating Temperature Range
32° F to 95 ° F (0°C to 35° C)
Storage Temperature Range
-40° F to 158°F (-40° C to 70° C)
Dimensions (LxWxH)
13.6 X 9.13 X 35.18 inches (347 X 232 X 893mm)
Applicable Room Size
538.2 ft
2
(50m
2
)
Net Weight
21.6 lbs (9.8 kg)
CADR
300 CFM (510m
3
/h)
Remote Control Dimensions
1.77 X 0.79 X 4.13 inches (45 X 20 X105 mm)
Unpacking and Setup
1. Remove the unit from the box and check that all the items shown in Figure 1 are
included. It is a good idea to retain the packaging for storing the unit or in the event it
must be shipped back for service.
2. The unit is shipped with the 4-in-1 HEPA filter sealed inside a protective plastic bag.
Detach the bottom cover and remove the 4-in-1 HEPA filter from the plastic bag, then
replace it inside the unit and replace the bottom cover.
3. Locate the unit on a flat, solid surface in proximity to an AC electrical outlet.
4. Connect the AC adapter to the unit, and route the power cord to the outlet, but do
not plug it in yet. Make sure that the power cord is out of the way and does not pose a
tripping hazard, and is out of reach of children and pets.
Congratulations! You are now ready to enjoy clean safe air using the CleanAire 4 in 1 HEPA-
PLASMA Air Purifier.
Operation Instructions
The Control Panel
Operation of the unit is controlled by buttons on the Control Panel as showed in Figure 2.
Figure 2. Control Panel
Icon Description
Power ON/OFF Button. Controls operation of the unit. Pressing
the button turns the unit ON or OFF. Any time the unit is turned
on in the future it will start up the same operating mode it was
in when last operated.
Auto Mode Button. The inner light ring around the control panel
will work and indicate the indoor air quality as monitored by the
PM2.5 sensor:
Blue: Air Quality Good (0 to 100 μg/m
3
)
Yellow: Air Quality Moderate (100 to 200 μg/m
3
)
Red: Air Quality Poor (above 200 μg/m
3
)
The machine will automatically adjust the fan speed according
to the air quality. When the air quality detected is poor, the fan
speed is adjusted higher; when the air quality is good, the fan
speed is adjusted lower. The light will be off in standby mode.