Phau Ntawv Qhia

7 8Copyright © 2022 Dernier & Hamlyn Inc. All rights reserved.
Filter Replacement
3-in-1 HEPA Filter Replacement
The lter should be replaced every 12 months or whenever indicated by the red
illuminated on the Filter Replacement Indicator on the Control Panel. However this
interval is intended as a guideline only. In environments with a high concentration of
contaminants such as dust, pet dander, or cigarette/cigar smoke you may need to replace
the lter more frequently.
NOTE: The HEPA lter is not washable. DO NOT immerse it in water.
1.
Make sure the Purier is OFF and unplugged.
2.
Detach and remove the magnetic bottom cover from the unit.
3.
Remove using the pull tabs and replace the replacement 3-in-1 HEPA lter into the
Purier main body.
NOTE: Ensure that the pull tabs are facing outward to facilitate lter
removal later.
4.
Inspect the screen on the bottom cover and if necessary clean any excess dust or
dirt from the screen using a hand held vacuum.
5.
Replace the bottom cover by placing the bottom cover into the slots on the unit.
Gently push the top of the bottom cover into place.
6.
Turn on the Purier. After replacing the lter, press and hold the Filter Replacement
Button for 3 seconds to reset the lter life countdown.
Using the Schedule Function
Using the DH Lifelabs App operation you can set up a schedule to turn the Sciaire + HEPA
on or off time (like an alarm clock) in advance. You can also set up the desired operating
mode including, fan speed, plasma on/off function or sleep mode. For example, if you set
the machine on at 22:30 in sleep mode, it will be turned on immediately at 22:30 at night
and enter sleep mode.
Voice Control
Using the DH Lifelabs App operation you connect with your voice equipment for the
control, following the instruction codes your voice equipment have. Works with Google
Home or Amazon Alexa.
Using Wi-Fi & DH Lifelabs App
(only apply to CAHP-50XX02C Wi-Fi Enabled model)
Sciaire + HEPA can connect with your smart device when you download the DH Lifelabs
App. Follow the steps below and/or in the App.
1.
On your smartphone, install DH Lifelabs app and turn your Location authorization and
Bluetooth function on.
2.
Open DH Lifelabs app and add the device.
3.
There are two ways to add your device, pls kindly select either ways to help.
- Recommended way: Auto discovering device. Make sure the device is turned on, APP will
search for nearby devices automatically. Follow in-APP instruction to click "ADD", select the
device you have and click "+", APP will read your WIFI network and start to add the device
automatically.
- Add Manually. Select the device you have, APP will read your WIFI network, follow in-
APP instruction to turn on the device and long press WIFI button for 3s to pairing mode,
connect to the hotspot of the device in "SmartLife-XXXX", then APP will connect to the
device step by step.
To disconnect from the network, press the
Wi-Fi Status Indicator/Button. The unit will
beep and the indicator will ash red.
GET IT ON
GET IT ON
DH Lifelabs App