Users Manual

TWS Operation
Attention：Please make sure that the 2 speakers both NOT connecting with any mobile device before doing TWS
operation.
. Suppose A is host player
，
B is slave player
，
power on A and B one by one
，
Double click the power/mode button of
A
，
you will hear a “Ding-dong” prompt voice after 3-5 seconds when B connected with A successfully. Then
searching the Bluetooth pairing name “ NOR-XLB-WHT
” on your cell phone and click “ NOR-XLB-WHT”
，
A could play music once paired successfully
，
B will play the same
music at the same time.
. You could control the volume, songs selection, pause, play, power off by pressing the buttons of either audio player
during music playing.
. Double click TWS (BT) button means turn off this function after the 2 speakers connected together.
. TWS function ONLY could operate under Bluetooth mode
，
NO other modes.
Technical Parameter：
·Output power
：
1x7W
·Working voltage
：
DC 3.7V
·Built-in battery: 3.7V / 1800mAh.
·Input voltage: DC 5V/1A
·Frequency: 60Hz-18 KHz
·Bluetooth version: 5.0
·BT operating range: 10m (no obstacle distance)
· SNR: >60dB
·Distortion:
＜
10%
·Support MP3: bite rate, 32kbps-320kbps
Cautions
You will need to confirm to comply with the following basic safety instructions to guarantee safe
and reliable use of the product.
•It is not allowed to make the product fall or suffer from thump.
•It is not allowed to make the product close to high magnetic field.
•It is not allowed to make the product close to high temperature heat source, or dry or blow the
product at high temperature.
•It is not allowed to disassemble, repair or remake the product.
•Do not listen music at a high volume for a long time in case a bad effect on hearing.
•It is not allowed to use clean water to clean the speaker, a slightly wet cleaning cloth is workable.
•Please charging in time and unplug the charging cable when fully charged to extend the battery
lifetime.
•Please properly handle the waste packaging, battery and waste electronics with corresponding
classification.