Specifications

Getting Started 1-2
values. In most cases, a module in Default Mode may not be used in a string
with other modules.
RS-232 & RS-485 Quick Hook-Up
Software is not required to begin using your D1000 module. We recommend
that you begin to get familiar with the module by setting it up on the bench.
Start by using a dumb terminal or a computer that acts like a dumb terminal.
Make the connections shown in the quick hook-up drawings, Figures 1.1 or
1.2. Put the module in the default mode by grounding the Default* terminal.
Initialize the terminal communications package on your computer to put it
into the “terminal” mode. Since this step varies from computer to computer,
refer to your computer manual for instructions.
Begin by typing $1RD and pressing the Enter or Return key. The module will
respond with an * followed by the data reading at the input. The data includes
sign, seven digits and a decimal point. For example, if you are using a
thermocouple module and measuring room temperature your reading might
be *+00025.00. The temperature reading will initially be in °C which has
been preset at the factory. Once you have a response from the module you
can turn to the Chapter 4 and get familiar with the command set.
All modules are shipped from the factory with a setup that includes a channel
address of 1, 300 baud rate, no linefeeds, no parity, alarms off, no echo and
two-character delay. Refer to the Chapter 5 to configure the module to your
application.
Figure 1.1 RS-232C Quick Hook-Up.