Specifications

Communications 3-3
Figure 1.1 shows the connections necessary to attach one module to a host.
Use the Default Mode to enter the desired address, baud rate, and other
setups (see Setups). The use of echo is not necessary when using a single
module on the communications line.
Multi-party Connection
RS-232C is not designed to be used in a multiparty system; however the
D1000 modules can be daisy-chained to allow many modules to be
connected to a single communications port. The wiring necessary to create
the daisy-chain is shown in Figure 3.1. Notice that starting with the host,
each Transmit output is wired to the Receive input of the next module in the
daisy chain. This wiring sequence must be followed until the output of the last
module in the chain is wired to the Receive input of the host. All modules in
the chain must be setup to the same baud rate and must echo all received
data (see Setups). Each module must be setup with its own unique address
to avoid communications collisions (see Setups). In this network, any
characters transmitted by the host are received by each module in the chain
and passed on to the next station until the information is echoed back to the
Receive input of the host. In this manner all the commands given by the host
are examined by every module. If a module in the chain is correctly
addressed and receives a valid command, it will respond by transmitting the
response on the daisy chain network. The response data will be ripple
through any other modules in the chain until it reaches its final destination,
the Receive input of the host.
The daisy chain network must be carefully implemented to avoid the pitfalls
Figure 3.1 RS-232 Daisy Chain Network.