Datasheet
Table Of Contents
- General Description
- Pin Assignments
- Absolute Maximum Ratings
- Electrical Characteristics
- Typical Operating Characteristics
- Detailed Description
- Register Description
- Application Information
- Package Information
- Tape & Reel Information
- Soldering & Storage Information
- Laser Eye Safety
- Ordering & Contact Information
- RoHS Compliant & ams Green Statement
- Copyrights & Disclaimer
- Document Status
- Revision Information
- Content Guide
Page 54 ams Datasheet
Document Feedback [v1-08] 2020-Jun-29
TMF8701 − Ta p e & R eel I nfor mat ion
Figure 120:
Tape and Reel Drawing
Note(s):
1. All linear dimensions are in millimeters. Dimension tolerance is ± 0.10 mm unless otherwise noted.
2. The dimensions on this drawing are for illustrative purposes only. Dimensions of an actual carrier may vary slightly.
3. Symbols on drawing A0, B0, and K0 are defined in ANSI EIA Standard 481-B 2001.
4. There are two reel sizes available (see section Ordering Information)
a. 7’’ reels: Each reel is 7 inches in diameter and contains 500 parts.
b. 13’’ reels: Each reel is 13 inches in diameter and contains 5000 parts.
5. ams packaging tape and reel conform to the requirements of EIA Standard 481-B.
6. In accordance with EIA standard, device pin 1 is located next to sprocket holes in the tape.
7. This drawing is subject to change without notice.
Tape & Reel Information