Datasheet
Table Of Contents
- General Description
- Pin Assignments
- Absolute Maximum Ratings
- Electrical Characteristics
- Typical Operating Characteristics
- Detailed Description
- Register Description
- Application Information
- Package Information
- Tape & Reel Information
- Soldering & Storage Information
- Laser Eye Safety
- Ordering & Contact Information
- RoHS Compliant & ams Green Statement
- Copyrights & Disclaimer
- Document Status
- Revision Information
- Content Guide
Page 4 ams Datasheet
Document Feedback [v1-08] 2020-Jun-29
TMF8701 − Pin Assignments
Note(s):
1. SDA, SCL, INT and EN have no diode to any VDD supply. Therefore even with VDD=0V they do not block the interrupt line or I²C bus.
2. GPIO0 and GPIO1 are push/pull output and have a diode to VDD; therefore if VDD is not powered, GPIO0 and GPIO1 should not be
driven from outside.
6SDA I/OI²C serial data
7 VDD Supply
Chip supply voltage (3V); add a capacitor
GRM155R70J104KA01 (0402 X7R 0.1μF
6.3V) to GND
8 GND Ground
Chip ground; connect all ground pins
together
9EN Input
Enable input active high; setting to low
forces the device into shutdown and all
memory content is lost; connect to VDD if
not used
10 GPIO1 I/O
General purpose input/output; default
output low; leave open if not used
11 GNDV Ground
VCSEL ground; connect all ground pins
together
12 VDDV Supply
VCSEL supply voltage (3V); add a capacitor
GRM155R70J104KA01 (0402 X7R 0.1μF
6.3V) to GND
Pin No. Pin Name Signal Type Description